![]() ![]() Hover the cursor over the image below to show the behavior as the 3 shortcut is pressed. So if you had the entire board shown in 2D mode, then switched to 3D mode and zoomed in, when you switch back to 2D mode the entire board will be shown. When you switch between 2D and 3D view modes, the default behavior is to switch back to the last-used view in that mode. Controlling the View as you Switch Between 2D and 3D View Modes Use the keyboard keys in combination with the right mouse button to orient the 3D view. The video below demonstrates most of these view control techniques. When the PCB editor is in 3D Layout Mode, you can see a list of the shortcuts by displaying the View » 3D View Control submenu. Right-drag sphere when the Circle Segment is highlighted – rotate the view about the Z-plane.Right-drag sphere when the Vertical Arrow is highlighted – rotate the view about the X-axis.Right-drag sphere when the Horizontal Arrow is highlighted – rotate the view about the Y-axis.Right-drag sphere when the Center Dot is highlighted – rotate in any direction.Move the mouse around to highlight and select the required control on the sphere before right-clicking: Rotational movement of the model is made about the center of the sphere (position the cursor before pressing Shift to display the sphere), using the following controls. When you hold the Shift key down, a directional sphere appears at the current cursor position (as shown in the animation below). This setting is determined by the 3D Scene Panning option that can be accessed and edited in the Other region of the PCB Editor - General page of the Preferences dialog. The pan distance step is set to 500mils ( 12.7mm) by default. Numeric keypad, in combination with the Ctrl key:.Roll mouse-wheel (vertical) or Shift+Roll mouse-wheel (horizontal).In the PCB editor 3D Layout Mode, you can fluidly zoom the view, rotate it and even travel inside the board using the following keyboard and mouse combinations: Zooming To access this mode, select the View » 3D Layout Mode command from the main menus, use the 3 shortcut, or switch the 3D option in the General Settings region of the View Options tab of the View Configuration panel to the On state. This page describes the PCB editor's features to control the presentation of the board in 3D Layout mode. The PCB editor is a true, 3D design space, where you can easily toggle between the 2D and 3D display modes. Controlling the View as you Switch Between 2D and 3D View Modes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |